[markham335i]

hey everyone hope u all had fun at euro fest today and it was nice meeting u all! i managed to get a dyno run in and these are the results:

mods:ar catless downpipes, dci, bmw per exhaust, jb3

map 0: 229hp 213torque
map 5: 280hp 258torque
map 7: 310hp 304torque

i dunno if thats correct im assuming thats to the wheel.. wonder how much that is crank..

btw the real reason i wanted to post is to tell everyone they forgot to screw in my engine cover and left the bolts on the edge of the engine bay (i drove away thx god the bolts didnt fall out..)

then i went to do some drag and after doing that i popped the hood and noticed they left there snap on tool near my ecu...free tool for me but could have caused some damage on the strip.. damn hicks

[triggz]

Your dyno results seem very low. Something isn't right. Stock 335i is 280 on the dyno.

[markham335i]

yeah i dont think that dyno was very accurate =\

[bulldog_yyc]

Id recommend champion motors, they have a great dyno setup there

[Mike@N54Tuning.com]

Originally Posted by markham335i

yeah i dont think that dyno was very accurate =\

Told you not to dyno there those stock numbers are WAY off.

Mike

[markham335i]

Originally Posted by Mike@N54Tuning.com

Told you not to dyno there those stock numbers are WAY off.

Mike

lmfaooooo i knew u were guna say that.. yeahyeahyeah u told me so :P

[markham335i]

Originally Posted by turkish335

Id recommend champion motors, they have a great dyno setup there

thanks man iv heard great stuff about them and was planning on doing some dynos there soon

[Mike@N54Tuning.com]

Originally Posted by TrackRat

They probably don't use a bogus 30% correction factor to inflate the power numbers.

So you think 21x whp/wtq stock is legit?

Mike