[Panoz]

I cant seem to find what this code is. The best thing I could find is

2A94- Crankshaft sensor, signal

But still cant really understand what could possibly caused it.

[OpenFlash]

Originally Posted by Panoz

I cant seem to find what this code is. The best thing I could find is

2A94- Crankshaft sensor, signal

But still cant really understand what could possibly caused it.

If you unplug (or lose power to) your PROcede while the car is running. Or tried starting it while it wasn't plugged in fully, you will throw that code. Just clear it and see if it comes back. If it reoccurs while the car is driving, then you might have a bad Crankshaft position sensor.

Shiv

[WOPALX]

Originally Posted by Panoz

I cant seem to find what this code is. The best thing I could find is

2A94- Crankshaft sensor, signal

But still cant really understand what could possibly caused it.

What were the conditions when it occurred?

[Panoz]

Originally Posted by shiv@vishnu

If you unplug (or lose power to) your PROcede while the car is running. Or tried starting it while it wasn't plugged in fully, you will throw that code. Just clear it and see if it comes back. If it reoccurs while the car is driving, then you might have a bad Crankshaft position sensor.

Shiv

Thanks!! Now I know where it comes from...

Originally Posted by WOPALX

What were the conditions when it occurred?

I just checked my stored codes and it came-up into the list. It possibly comes from a day I was experimenting with my Procede device and attempted to start the car without the main unit plugged into the harness...