|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Freshly installed JB4 - ISO question
|
|
08-13-2014, 06:18 PM | #1 |
Enlisted Member
8
Rep 40
Posts |
Freshly installed JB4 - ISO question
So I just installed my JB4 last week and I am loving it. I use ~E30 and map 5 is very strong, holds 15psi very well.
I do notice however that under WOT boost pressure will increase to about 10-11 psi, hesitate for a half second or less, and then proceed to boost up to the 15 psi nicely. I have read post on here that the ISO firmware will build/control intake pressure more smoothly. Anyone else have experience with this? |
08-13-2014, 09:06 PM | #3 | |
Lieutenant
28
Rep 583
Posts |
Quote:
__________________
JB4 G5 ISO FF | BMS Performance Intake | BMS Wheel Spacers | VRSF Catless DP | Red CYBA Scoops | Supreme Power Lowering Perches | VRSF Charge Pipe | VMR 810 19x8.5 ET35 19x9.5 ET33 | Michelin PSS 235/265 | BMS CDV | BMS Clutch Stop | 4'' Tips
|
|
Appreciate
0
|
08-14-2014, 11:32 AM | #4 |
BimmerPost Supporting Vendor
24198
Rep 190,805
Posts |
+1 for logs
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
Bookmarks |
|
|