[hl0m4n]

for those of you who did the golf tee mode with a 7/32" ball bearing or a 4.5mm bb could you reverse and take the ball bearing or bb out? im asking b/c there was a user that used the 7/32" bearing and couldn't take it out thus he had to cut the wire. even though he said there is enough wire to cut 1 inch off, i still want to know.

and for those who used a bb, did you guys use a plastic or metal one? im worried that the plastic bb will melt?

[phantom330]

use metal, and what goes in should come out, you'll just have to work it out.

[SpiralOut]

Why not just disconnected the solenoid near the rear tail light.... seems so much easier than the BB thing.

[billspreston]

Originally Posted by SpiralOut

Why not just disconnected the solenoid near the rear tail light.... seems so much easier than the BB thing.

fault codes are stored with this solution.

[HyperM3]

Originally Posted by hl0m4n

for those of you who did the golf tee mode with a 7/32" ball bearing or a 4.5mm bb could you reverse and take the ball bearing or bb out? im asking b/c there was a user that used the 7/32" bearing and couldn't take it out thus he had to cut the wire. even though he said there is enough wire to cut 1 inch off, i still want to know.

and for those who used a bb, did you guys use a plastic or metal one? im worried that the plastic bb will melt?

A) Put the bearing in with some grease so its easier to get in or out. B) I used a plastic airsoft BB. Ive done it on about 10 cars now with no problems. C) why would the BB melt?

[ontopofm]

anyone have a diy?

[HyperM3]

Originally Posted by ontopofm

anyone have a diy?

1) Pull hose from valve
2) Grease bb and slide it into tip of hose
3) Press hose against nipple on valve pushing bb further into hose

Done.

[slant83]

Originally Posted by billspreston

fault codes are stored with this solution.

Screw the codes!! it goes vroom vroom and takes 2 sec to plug in..Just blame a loose connection if the dealer has a problem. It shouldn't affect anything

just my .02

[asdflkijd]

Originally Posted by slant83

Screw the codes!! it goes vroom vroom and takes 2 sec to plug in..Just blame a loose connection if the dealer has a problem. It shouldn't affect anything

just my .02

+1