Good to know, but yeah I'll probably replace the sensors through FCP Euro. Still need to check them out, actually, but I digress.
Quote:
Originally Posted by Maynard
You may want to pull some brake fluid out if there isn't much room above the fill line (at least watch it after each set of pads to be sure you aren't overflowing) - haven't done brakes on a BMW, but in the past it would sometimes overfill the reservoir, spill out in engine compartment where it is impossible to clean fully, and then eats away paint. My buddy had a trick metal 'turkey baster' for this - DK if it will dissolve regular plastic ones.
|
I don't think there's any harm in you just taking some out using regular ones, as long as you're not letting it sit in the reservoir for extended period of time.
However, if you're at a point where there's too much fluid, you might as well just bleed out some old fluid.