Quote:
Originally Posted by Rich@GTBPerformance
Quote:
Originally Posted by tonymac1
Not very sure but i think it's 10.5""? I used to put it on my e92 and used 295 in the rear with no rubbing. However, i talked to a tirerack guy and they said 295/35/19 will probably have a rubbing issue...
|
The offsets on the E9x M3 Rears are a bit lower than the F8x. By default your HRE's would have a lower rear offset than a set they'd configure for the new M3/M4
For reference :
E9x ZCP 19" Wheels (Competition)
Front : 19x9 ET31
Rear : 19x10 ET25
F8x 19" Wheels :
Front : 19x9 ET29
Rear : 19x10 ET40
As your TireRack fellow said, you might not be able to go wider without rubbing. The more aggressive (Lower) offset on the E9x rears push those wheels out and if you bottom out your suspension, it might take half your fender with it if your tire is too wide.
See if you can find your build sheet from your HRE order, and let me know the offset. I should be able to offer some more helpful advice then
|
thanks for the reply! I will ask HRE about it and get back to you