[N55guy]

So I'm finally getting around to installing my Dinan springs and bump stops. I did coilovers on my e90 a few years back and I'm hoping I have everything I need for this install. Just a few questions for those of you who have swapped out your springs.

1. On my e90 I needed a knuckle spreader to get the front struts out, I'm guessing same tool for this?

2. Also I have a specific tool for the top strut nut that is open to allow an Allen wrench to fit as a counter. Is it the same for this car?

Any advise/tips beyond this would be much appreciated!