Quote:
Originally Posted by AlpineG05
Pretty easy to install just run the OBD cable through the hood latch cable grommet. FYI, it's a tight fit causing the grommet to rip a bit.
I also ran JB3 on my e90 335 (n54 motor)
|
Thanks
Also saw that there was a way to route it through the outside door into the fender and into the engine bay.
Side question though for AlpineG05,
I see in your signature you have some goodies which I would like to get.
I have a '19 xDrive50i so not 100% sure if you'd know this or not, but would your goodies (Intake and DP) fit the 2019 G05 xDrive50i
So it did not go according to plan. I took the metal brace off, metal plate up front, the side plastic covers, took the intake gromet off, pulled back the plastic hose underneith the grommet, but was unable to locate the tmap sensor.
Does anyone have pictures or guidance of where I can locate it from both sides.