Quote:
Originally Posted by pungo
Thanks for the input. Yes, as I mentioned in my original post I would need to swap the fog light switch (which is part of the LCM) from a non-M.
I was looking for a clean setup using a factory switch from non-M as I mentioned. I may need to add the wiring and a relay.
I'll have to look at the schematic for both the M and non-M and see what's there. Since the connector is the same for a M and non-M LCM, it might be as easy as adding a wire to the connector for the LCM and run it out to a relay to trigger it, then wire the fog lights to the relay. I can code the LCM to ignore the fog light cold and hot check if it throws an error.
|
Sweet, keep me updated on what you find, if you need me to test/try anything out from my end just let me know.