Quote:
Originally Posted by Aria335iN54
Thanks a lot for the good news!
Coding is done and fine, already have the stations sound.
|
Sound i carried over the fibre and not the FBAS, so as long s the fibre ring is good that will just work, (its why you see the station search etc). BTW you will need to do the station search from the TV and not the cic as the older units do not use the progress bar in the cic firmware.
Quote:
So need to follow your below guide I suppose:
cic single plug:
18: video +
27: shield
28: video
|
That sounds about right.
Quote:
Would you know by any chance which current pins on the cic connector need to be moved to above positions?
|
Off the rip of my head no, have a look in the TIS.
from the TIS
TV in on the ccc is
2: GND connected to pin 13 on tv now goes to cic
3: Red connected to pin 3 on tv
4: Green connected to pin 4 on tv now goes to cic
5: Blue connected to pin 5 on tv
11: shield connected to pin 12 on tv now goes to cic
Quote:
Also I suspect ccc has 5 wires ? so is it ok to leave the other 2 on the connector or need to be disconnected to avoid any issues?
|
i would say so... I only ever had 3 pins connected when i have done this retrofit.