|
just fyi - i just did this and used the blendmount MirrorTap MTX. i was concerned about length because i didn't want it too long or short, but it turns out there is tons of space behind the mirror housing. i ordered the 15" cable and easily tucked the slack into the housing.
i found the housing to be easily removed by pushing up/into the housing to snap it apart.
the blendmount wire is nice and tidy. it comes with multiple spade sizes but my largest one was too short (solder joint in wrong place). Blendmount is sending me a replacement set, but the second to largest size works for now. it is a bit loose and a couple of cable ties should help.
i recommend the blendmount set but it is a bit pricey and adds an additional failure point (tips are swappable and where they push together isn't the tightest connection).
|