Quote:
Originally Posted by AGS
Quote:
Originally Posted by BMA89
To be honest I'm not sure as I dropped it off at my trusted mechanic and then picked it up a few hours later. Didn't ask about the difficulty but I believe if you have access to a lift it's relatively easy as it's OEM fitment I believe.
Mike @ XP-H will likely be able to give more insightful feedback.
|
Quote:
Originally Posted by mike@x-ph.com
It's a straightforward install; I doubt it took them longer than 1 hour on the lift to complete it
|
Quote:
Originally Posted by BMA89
Yes it's bolt on so everything is included
|
I was just talking to my installer about these. A couple questions if anyone can answer:
1. From the quoted posts above it sounds like these are a direct swap for the OEM component with no cutting necessary. Just undo the clamp at each end and replace, then repeat on the other side. Correct?
2. Can this be done with the rest of the exhaust system in place? Or do you need to drop the exhaust to have enough clearance to make the swap?
Thanks in advance! |
Question 1. Correct
Question 2. My mechanic said he did have to drop the exhaust to get the mid pipe out.
I confirmed both questions for you with him as I'm not super technical with this stuff.
Hope that helps!