While not for everyone, I think the Red Start/Stop button adds a nice subtle touch of interior style. Here’s the one I purchased…
https://autotecknic.com/products/aut...01-x3-g02-x4-1
This inexpensive mod is way easy using the sticky putty method. Takes all of 5 minutes to complete.
1. Clean and lightly warm factory Start/Stop button area with hair dryer or heat gun (on low setting).
2. Warm sticky putty in hands to soften.
3. Press sticky putty over surface of factory Start/Stop button and form small cone to grab on to later.
4. Let sticky putty set for about 5 minutes to firm.
5. Quickly and firmly pull cone of putty and factory Start/Stop button easily comes off. Note: This may take a few attempts.
6. Line up colored replacement button and press gently until it snaps in place,
7. Test and enjoy.