|
You can fit dual 3.5" tips on the 50i bumper, this pretty much maxes it out as you can see in the pics of mine below.
You could just cut your stock bumper too, a sawzall will make short order of it. I had to cut the backside of my bumper to make room for the actuators for the exhaust cutouts and a 40 dollar sawzall from harbor freight cuts through it like butter, I am sure your bumper is the same material.
Use a fine-tooth metal cutting blade so you can make nice smooth cuts, Then sand it down and contour the cut a bit and touch it up with some factory matched paint. With the tips in it, you wont be able to tell it was cut.
|