Proceede keeps going Valet - help!
Proceede v3 Rev 1 using the 7-3 maps and 123 firmware and new software.
I know these maps were more for the Rev 2 but as Shiv posted we can use them but just some functions will not work.
Anyways... i noticed that as soon as i turn on the car, everythings great. As soon as i begin driving, i can feel the proceede kick in and the car feels strong, and this is after car is at normal operating temp, but it goes into valet mode right away and i can tell by looking at my boost gauge and it shows it only at 7lbs and car feels stock.
I turn off car, turn back on.. get on it, i can see my boost gauge get up to about 10-11psi and then drops back to 7lbs and valet again.
I have Proceede V3 Rev 1, DCI, HKS Exhaust, UR HKS SSQV.
I just drove down south to LA and supposed to put in DownPipes tomorrow(today actually as its past 12am)
I'm going to clean the air filters as its been a while but not sure if that's what causing my problem of the proceede going into valet mode.
Also the maps is left default upon upload so i didnt change any user torque settings.
Any input is greatly appreciated.
Thanks!
|