Quote:
Originally Posted by Calvindubois
2023 G20 LCI
Must have S5AP- Decoding for Anti-Glare High-Beam Assistant / North America
Use BimmerCode & BimmerUtility, or Esys.
Under the BDC Module in expert mode, there are four groups labeled as LaMaster 1-4. The relevant ones are identified by LA1, LA2, LA3.
The values you'll need to adjust are found after the "|" in the lines below:
LA1
C_BLC_PRE_ENA | 1
LUT_FLC_FORWARDLIGHTING_Y | AFS
LA2
C_AFS_ECO_LEVEL_3_ENA | 01
C_AFS_ENA | 01
LA3
LUT_AFS_CODRV_HOR | standard/init
LUT_AFS_DRV_HOR | F040_G005_AHL...
C_CLC_CURV_V2 | 23
C_CLC_CURV_V3 | 28
C_CLC_EXT_ENA | 01
C_HBA_DIM_ENA | 01
C_HBA_GFHBA_ENA_V_HI | 3C
C_HBA_GFHB_ENA | 01
There are also four additional codings in the lane assist camera " KAFAS04" which are currently inaccessible with BimmerCode. However, BimmerUtility or Esys is available for these changes.
——
The below adjustments are expected to reduce the auto dim's sensitivity to streetlights and sign reflections, while also tightening the beams. The High Beam Assistant (HBA) should still perform exceptionally well even without these changes.
C_FLA_COUNTRY_WITH_MULTIPLE_REFLECTORS | 01
C_FLA_US_SENSITIVITY_MODE | 00
C_FLA_BS_ENTER_THRESH | 03
C_FLA_BS_EXIT_THRESH | 02
Let me know if you have any questions !  |
Hey Calvin,
I have done all the coding as mentioned, but to check whether it works or not. I did put the car on D and the left beam did not move in or out.
Tried to put it in R, and the beam did not move.
Is there something I'm missing?
Also, you stated S5AP must be enabled, how can I enable this using BimmerCode?
Thanks for your input.