[Westersund]

I've finally come around to scanning both front and rear axle of the F8X M chassis. I had a complete rear axle laying around for my Z3 Coupe project which made it a lot easier to scan. Would have been a nightmare to do it on the M2. The backing plates were a little rough so I had to make one of them as straight as I could.

My priority will be on making a product for the rear axle which mounts using the ABS bolt and an additional location, no modification will be needed excapt cutting a window in the backing plate for the air flow.

As for the front sometime next year there might be a product similar to the BMW M2 Cup cars use.