[Mik325tds]

Edit: Based on the discussion following this post I realized that the following needs to be put into context. Some members (including me) where wondering if it is possible to install the pipe first and then drive to Oakville, Ontario to get Jarek's tune. The question was if the car would be driveable or would go into limp home mode. Now follows the original post:

I started the engine with the downpipe installed and it seemed pretty content with the situation of missing multiple sensors. Obviously, the Check engine light (CEL) was on immediately. But that is normal for me as I had the EGR block-off plates installed for a while now.
I then pulled the diagnostic trouble codes (DTC) see attached list. After about 5 minutes of ignition ON the following message appeared in the Car Information Computer (CIC).
So the DDE does go into Limp home mode. Even though it says "Continued driving is possible", I wouldn't recommend driving several 100 miles in this state.